Description
6306 Bearing Puller – New 4 Leg Version – NOVEMBER 2026
Some Guys asked for a 4 leg version for extra stubborn bearings and help keep the puller centered and not walk off as it is tightened. So, here it is! This uses the same arms as the 2 arm puller.
ALSO NEW: Accessory Arm Support Donut. Available in open center that slips over the splines in any position, or a Theaded version for Type 1 Axles (36mm Castle nut) of you prefer it hard mounted on the end. This debut batch INCLUDE 1 each of the open arbor and threaded versions of the arm support brackets! These are NOT necessary to function, only if you feel are needed or use as paper weights.
Replacement Arms:
Same arms Used as the 2 Arm Puller. * 2 M8 x 70mm bolts are included and used to attach the second pair of arms due to clearance isuuses with standard m8 x 30mm bolts and nuts*
The tips can deform under serious force. Replacement arms available. Grab an extra arm now to save shipping later if you work on these often.
includes
1) new 4 arm block
Forcing Screw 5/8″ -16 with pointed tip
4) 6306 specific bearing puller arms
2) M8 x30mm bolts / nut
2) M8 x 70mm bolts /nut
1) Arm Support bracket – Open Arbor
1) Arm Support bracket – M24 x 1.5 Threaded (Axle Threads type 1 / 36mm castle nut)
Fitment:
- VW Type 1 Beetle, Ghia, Type 3 (Crashbox, Split Case, Tunnel)
- Long and Short Splined Swing Axles
- Some Porsche 356
- Type 2 Small Nut RGB (except 7-ball bearing)
Note: Factory axle spacer required. Spacer not included.
